SMC General Purpose Pressure Gauge

•Gauge
•42.5mm (1.65") diameter case
•0-150 PSI
•1/4 NPT Male Backside Thread
•Vendor Part Number: G46-P10-N02-X30

Note 1: When mounting a pressure gauge, use caution not to tighten excessively. Excessive tightening will cause product to be damaged. Use a pipe tape for sealing.Recommended tightening torque: R 1/8: Set between 7 and 9 N·m, R 1/4: 12 and 14 N·m respectively.

Note 2: Not applicable to water as fluid because its stub is made from aluminum die-casting. Water may cause corrosion and block the air passage. Use G46-X3 pressure gauge with wetted parts stainless steel (wetted parts of G46--01M are made of brass and this become lightly corroded. Take precautions when using.) Design system to not be affected by water hammer when using water as fluid. Similarly, when using other fluids, please consult SMC for fluid compatibility information concerning corrosive potential.